Flush Mount Kitchen Lighting – Substituting Lighting Flush Mount, the most important is what to do with the hole in the roof that let recessed lighting fixture. Locate the breaker that supplies power to the ground and off lighting. Place the ladder under the light. Remove the cover and bulb. Again the screws holding the cover plate on the electrical connections out with a screwdriver and remove the cover plate.
Locate the screws that hold the wiring recessed illumination. Turn counterclockwise until the cables can be removed from the fixture. Inspect the recessed illumination to see whether they can be removed from inside the room. Locate the mounting screws holding the lamp to the ceiling joists. The screws are removed with a screwdriver and remove the attachment hole. Place the timber between the rafters over the hole for the recessed flush mount kitchen lighting. Apply wood glue into the wood where it meets the ceiling beams.
Place the February 2 by 4s on the plywood (and glue) and attach them to wooden ceiling joists with drywall screws. Drill a hole in the center of the plywood with 1-inch spade bit and electric power cables through the hole. Down in the attic. Insert the ends of the white wire from the ceiling and the white wire recessed flush mount kitchen lighting a wire nut and turn the nut until firm. Repeat this process with the black cable. Hold the recessed fixture in the ceiling according to the manufacturer’s instructions. Install the bulb and cover. Turn on the switch.