Belt Driven Ceiling Fan – Ford F-150 uses a belt driven ceiling fan to control the temperature of the engine. Belts “V” toothed belts or “V” ribbed belts can be used to drive the cooling fan crankshaft pulley. There are several symptoms that may indicate a problem that must be addressed before the belt driven ceiling fan starts on the road. Listen for a rhythmic noise that may indicate missing sections inside the belt. Inspect the belt for signs of stripes, glazing, cracks, fraying, cracks or oil deposits. Replace belt if any of these conditions.
Install a socket and 1/2 inch breaker bar in the pivot bolt automatic tensioner. Turn the adjuster to the motor until the belt driven ceiling fan is loose. Slide the belt tensioner and pulleys. Slowly ease the switch down and release the tension bar. Thread the new belt around the pulleys. Hold the ribbon near its position near the tensor. Install the socket and breaker bar on the tensioner and turn the engine until you can slide the belt driven ceiling fan tensioner. Slowly release the breaker bar until the tension is pressing on the tape.
Make sure the tape is fully seated in the pulley before releasing the automatic tensioner. The belt driven ceiling fan is flat in the slot and does not travel on each side of the pulley when fully seated. That explanation about way to replace a belt driven ceiling fan. Hope this post can help you or inspire yo to decorate your home.